Your eyes on the ground.

Connect soil, weather, water and crop sensors in minutes. The data a grower irrigates on, and the record an agronomist reports from.

Talk to sales
A Wildeye logger mounted on a steel post beside a soil-probe access tube, in a cotton crop with drip line running between the rows.

Soil moistureIs your irrigation reaching the root zone?

Sensors under the crop show how deep each watering actually went, while a pressure reading on the drip line confirms the system ran the way you planned it.

  • Avoid over-watering and "just in case" irrigation
  • Confirm each irrigation reached the root zone
  • Stop fertilizer being flushed past the roots
  • Make sure seasonal crops never run short
Permanent tree & vine cropsAlmonds, walnuts, pistachios, plums, grapes — and turf
Connects: Sentek · EnviroPro · Hydroscout 40/80/120/160 cm, every depthKit: Multi-level profile probe
Seasonal cropsVegetables, berries, alfalfa and hay
Connects: Sentek · EnviroPro · Hydroscout 10 cm (4 in) single depthKit: Single-level profile probe
Connects: Watermark tension sensors up to three per deviceKit: Tensiometer
Wildeye loggerOutdoor 3 dB antennaSolar panel on its mounting bracketPressure transducerMulti-level soil moisture profile probeSensor expanderAntennaWildeye loggerSolar panelProfile probeExpanderPressure sensor
Assembly diagram: a Wildeye logger with an antenna and a solar panel, port 1 running through an M12 coupling and a service loop to a multi-level profile probe, and port 2 running through a coupling to an expander and on to a pressure transducer.
Multi-level profile probe kit, as it arrivesLogger, solar or battery and an outdoor antenna in every kit. Every part arrives on its own M12 screw-coupled lead. Gateways required: 0.
Every kit, in full

Why growers choose Wildeye®

Set up by the grower.Read by the agronomist.

The grower bolts the device to a post, plugs in the sensors and presses the button. The agronomist has the first readings before the ute leaves the paddock.

Each device reports over cellular straight into the Wildeye® platform, where the readings become graphs, maps and the alerts you set yourself.

The device is sealed to IP68 and runs off its own solar panel. It needs no mains power and nothing built around it, and it stays out through the season.

One button to activate

Press it once and the device is reporting. There is nothing else to install first.

Up and running in minutes

Plug in your sensors, confirm a signal and check your first readings immediately via the app.

Compliance-ready reporting

Automated SGMA, NRM and sustainability reporting with data export to your preferred platforms.

Years between visits

Solar charging and low-power cellular keep the device reporting for years at a time.

Tell us what you grow, and how deep.We will match the probe to the block and the alert to the season.

Talk to sales